Gizmo Supply 60CM 5050 18SMD LED Flexible Strip Light DIY for PC Computer Case

They were cheap so I was a bit skeptical at first but they seemed to have good reviews so I figured I would give it a shot in ordering these. They work really nicely. The adhesive is not the best but I had no problem getting them to stick and I just took a small amount of tape to tape down the wires at the end so they wouldn't pull the strips off the side of the case.I would definitely recommend these for someone wanting some good LEDs for their PC. They are also pretty inexpensive so I figure if they do fail on me, I didn't have a lot invested in these anyway. I ordered two strips, one for each side of the case. My only complaint is that the molex wire on the end could have been a little longer to allow for more distance between the mounting point and the back of the case where all of my cables are but I still had no issue with that.

Very nice LEDs ! two strips light up my full tower case.and the price cannot be beaten !Cons:- get a little warm.- adhesive material is not good but you can fix this with tape or something else.but overall, I'm satisfied with this product and hope to lasts for long time

the molex pins were flimsy and I needed to use a pen to sort of bend them back into place so i could daisy chain them togetherBut once that was done all was well, for the price this is amazing.. Very Bright almost too bright for how many I put into my case. I'm not fond of the red I purchased but for the price i'm going to order all other colors.Simple installation and a great bang for your buck.

Purchased two of these which both had issues. The plastic molex connector housing was broken on one strip and the other one had some pretty shoddy soldering which resulted in only having two thirds of the LEDs lit up. I ended up fixing both of them myself with a spare molex connector and a soldering iron. The adhesive is pretty much a joke but easily remedied with some 3M tape.I bought these hoping to pop them in and be on my way but it probably would have been less of a hassle if I bought a roll of SMD LEDs/double-sided tape and fashioned them myself.

The adhesive on the strip was terrible, it lasted less than 12 hours, I had to use thin strips of duct tape to secure it.

I got two of these strips to spice up the inside of my case. While the LED strip is pretty good, well made and has a nice sheathing for the wire, it has some issues in both the Molex Plug and the adhesive backing.The plug, while it is nice to be able to plu something else in with the plug, it is not well made. My corsair power cabling pushed the pins out of one of the housings and cracked open the plastic plug on the LED light from firm and consistant pressure pushing the plug in. They do not plug in well as a side note. The plug is the major issue with the product. While I got it to work (by taping up the plug and pushing pins back down into the cabling) it was very very flimsy.The adhesive is also unable To hold up the LED lights positioned at the top of my case. I will be purchasing some sort of tape to hold it up.All in all it is a decent product. With the plug you kinda get what you paid for, however, it is of dubious quality. The LEDs are bright and the strip itself is very nice. Do I like them? Yes, for the most part. I got what I paid for and minus the adhesive problems, I'm not overly dissapointed.

This thing is dope. I was a little worried when I saw other users mentioning how bright it is, but what I didn't realize is that these lights are meant to be placed at the ceiling of the desktop case, not in direct view. So the brightness of these lights is perfectly appropriate. It looks just right.

Does its job very well, and for 3$ the build quality is very well, rubberized led strip coating and a very nice braided mesh wire-wire coating. 3m tape on bottom does good no complaints their.