JoinfworldEV Charger Holder Wall Mount Kit EV Charger Holster Dock for SAE J1772 Connector J-Hook EV Charger Cable Holder & EV Charging Box Holder for Electric Vehicles

It does what it says. It looks good and made of metal. Sturdy and easy to install. The port that hold the plug that goes into your car is made of plastic, which is sufficient to hold it in place. The section of the charger that goes from the 240v outlet into the brick gets really hot. So it’s nice to have something to keep it away from touching anything. It does not come with instructions, so if you’re not handyman savvy, you will have to YouTube how to install. You will need a 5/16 drill bit so that the wall anchors can go in without a lot of pressure. Try to get the square cage/mount as close as possible so that the brick is touching the bottom of the mount. This will help support it over time and gravity not pulling as hard on the plug. It comes with a small trim that goes along the bottom of the mount. Took me a minute to figure that out. But hey, no instructions. Outside of that, it works great and is sturdy. We unplug the cable from the brick when not charging. It can be a little tricky to maneuver, so you may need to slightly bend the cable.

Good wall mount. Sturdy and easy to install.

The media could not be loaded. This charger block holder worked very well with bulkier 240V, 9.6kw Level 2 charger block 2024 BMW flex charger. Enough room for the block for better heat dissipation. Takes the thicker charging cable with no problem. The soft protective sleeve is a plus. The cable holder holds 2 longer loops with ease and can take more shorter loops if needed. With J1772 holster the cable is tangle free, easy to use and holds neatly when not in use. Good quality metal and plastic. Does the job as intended.

The item arrived on time, and it was an easy install and a perfect fit. The item is sturdy and well-constructed. The only problem was that there were no directions, and I couldn't figure out where the strip of padding was supposed to go, but I was able to figure it out by reading another review. Other than that, no instructions were needed, and I totally recommend this item.

Easy install with the proper tools. 2 months later and I am still happy, I use it almost everyday due to the type of car I have, and it works as expected for the great value it was.

It’s kinda expensive for what it is but not bad quality.

This is a compact, easy to install way to keep the charger cable and nozzle neat and safe when not in use.

This holds the charger that comes with the 2025 BMW iX perfectly!

Upon opening the box and unwrapping the protective plastic I found that the unit I was delivered had several pre-existing gouges in the finish. It seemed like it had been previously used. Worried that the unit would rust through these gouges, I immediately returned it.