EZDIY-FAB Addressable RGB LED Strips with Magnet for PC Computer Case, with Remote Control (Compatible with ASUS Aura Sync and MSI Mystic Light Sync)-2 Pack 40CM

Bought for a PC case and installed for a month now. Good adhesive and very bright LEDs. No complaints.

note that you will need a MOLEX cable to power them. the 3 pin connector doesn't connect as most of the modern motherboards are 4 pin connectors. so have a free molex cable to use.otherwise it is a quite good product

good

It's good but very expensive

One of the Best In Market ..

Bright and high quality!

Good

Macht was es soll und ist OK

Ottimo

Being from EZDIY-FAB I would have thought that they would have come with wires to connect the LED strips to the EZDIY-FAB hub similarly to the fans but unfortunately not.Otherwise, the colours are great and is compatiple with ASUS Aura Sync once I bought the connectors to the hub. The strips are magnetic the packaging was small which was nice.My current case is the Phanteks P400A and the strips fit perfectly along the bottom and top, not ideal for smaller cases though unless you cut them.Overall, they're cheap, decent led strips which I can't fault

the LED strips are bright and easy to install, just plug in and go! (no drivers driver updates or additional software required - besides big brand lighting control software which you likely have installed if you don't plan on using the remote controller) some reviews have complained about a lack of magents, the magnets are actually part of the tear back adhesive backing, so if you want to use the magnets, do not pull back the adhesive tape strip. in my case the lighting controls was handled by MSI mystic lights and is linked directly to the motherboard lighting settings, so that is something to bear in mind if you have an RGB motherboard and want different lighting modes for your strips to the motherboard.My only complaints are that the strips were a little too wide to easily fit into the grooves on my PC case, but with a little force i managed to get them into position, and that the magnetic strip isn't very powerful so they are liable to pull loose if you have tension on the cables (as part of cable management)as with all EZDIY-FAB products, the boxing is clean and simple,contained withing are 2x 3-pin ARGB LED light strips- with adhesive magnetic strip, 1x RGB 3-pin header splitter, 1x Remote control, 1x dual header remote controle node with 2 3-pin RGB connectors and 2 pin molex power plug. the packaging was handled by amazon, and arrived to me in perfect condition and on time

Well, not what I was actually expecting.They're really decent, bright and colourful.The packaging was small but efficient and the presentation was fine. The inclusion of a remote was alright, but I really wish you had an option for just the 2 cables as these are now waste!About the strips! They ARE magnetic! They are fixed to my case with the magnets for now until my replacement H115i comes, the strips are working with the supplied splitter (even though the board has 2 sockets) and I have one strip running the opposite direction, this is the effect I wanted. Obviously if you put them the same direction (wires going out same side) then they would be precisely the same.In terms of the length they were slightly longer than 40cm, the magnets are on the far end.For the bottom of my glass these were far too long, I cut the magnet off the strip and still they were, going that led strips can simply be cut to length I did a gamble with this kit and cut the last RBG off the end, this made my kit the perfect width to fit the case at the bottom.All in all, can't fault the product at all, it's cheap, bright punchy colours and works with my motherboard entirely.What else could you want?